Connecting the Storango SCM200/SCM400 to the Network 2 & 4 DRIVE USER GUIDE
Page 6 of 57
Power Connector: Use this port to connect power to the SCM200/SCM400. The SCM400 uses a standard computer
type AC power cord, whereas the SCM200 uses an AC to DC power adapter.
System Setup
This
section
gives
instructions
on
how
to
setup
the Storango
SCM200/SCM400.
Connecting the Storango SCM200/SCM400 to the Network
Connecting the Ethernet cable and power:
Connect
the
Ethernet
cable
to
the
Ethernet
port
on
the
rear
of
Storango
SCM200/SCM400.
Connect
the
other
end
of
the
Ethernet
cable
to
a
switch
or
router.
Connect
the
power
to
the
power
connector
on
the
rear
of SCM200/SCM400.
Connect the other end of the power cable or adapter to the nearest power receptacle.
Connecting a USB drive:
Connect
the
USB
cable of your USB hard drive or the USB flash drive
to
the
USB
port
next to
the
Ethernet
port
on
the
SCM200/SCM400.
Connect
the
other
end
of
the
USB
cable
to
the
USB
drive, if necessary.
Connect
the
USB
drive
to
power, if necessary.
Connecting a USB printer:
Connect the USB cable to the top USB port on the rear of the SCM200/SCM400.
Connect the other end of the USB cable to your USB printer.
Install the printer driver if it is not installed on the computer you are printing from.
Turning the System On
Power the system on after confirming that all the cables have been connected properly.
LED’s
will
flash
and
turn
different
colors.
After
30
seconds,
verify
LED’s
are
on
and
correct.
The
power
button
and hard
drive
LEDs
should
be
green.
Network
LED
should
be
green
and
may flash.
The SCM200/SCM400 and the computers must be on the same subnet, and DHCP/DNS must be enabled from
either a router or a server. If you are uncertain what these terms mean, contact your network administrator or the
manufacturer of your router.
Comentários a estes Manuais